ENGINE
MOUNTING POSTS
Our
standard posts are available in three styles:
1
– for bolting
to bumper-top or horizontal surfaces (needs to be
located high enough so winder can be used without
having to bend over).
2 – for bolting to vertical surfaces such as engine panels or beaver
tail.
3
– receiver models available in two different rises,
10 inch for larger brush engines and 22 inch for
utilities and lower type 5 engines. We also offer the
mounting post alone. Comes with the stainless index
pin and is machined to accurately fit the winder
receptacle tube (
this is important to ensure the tube notches on the
winder locate uniformly to balance the load during
winding operations ).
