See how the winder and harness system works
See how the hose pack deployment works
|
The PORTA WINDER was designed for use with 1" and 1-1/2"
wildland firehose. It mounts on the engine using the common "FORESTER" donut
roller post. If one is not available, we make posts in both receiver or weld on
configurations. Setup takes less than a minute, and requires no tools. This is possible by
means of the permanently attached fasteners, and hose cam actuated arm adjusters.
The
PORTA WINDER'S adjustability
This is particularly useful as most engine's
hose compartments differ. The ROLLER/GUIDE attaches
to the winders extension arm to efficiently evacuate air and water, while guiding
the hose. It can be used with either the PORTA WINDER or DONUT ROLLER.
This attachment makes the winding operation manageable by a single person, and
doesnt require any real organizing of the hose section prior to winding.
|
|
The DONUT ROLLER was designed to be lightweight and simple. Like the PORTA
WINDER it attaches to the extension arm spindle, on either side, allowing the
winder to be used in various directions on the engine.
Each of the winders components have their own pocket within the storage roll-up,
including the DONUT ROLLER. This roll-up pouch is fastened
with compression straps for secure storage during transport The ROLLER/GUIDE
comes with its own storage pouch. |